Raeticodactylus is a genus of non-pterodactyloid pterosaur from the late Norian-early Rhaetian-age Upper Triassic lower Kössen Formation of the central Austroalpine of Grisons, Switzerland. It is known from holotype BNM 14524, a single disarticulated partial skeleton including an almost complete skull, found in August 2005. This genus was named and described in 2008 by its discoverer Rico Stecher; the type species is Raeticodactylus filisurensis. The specific name refers to Filisur.
I built this frame to use 3" props with 1S Lipo (or LiIon).The RCinPower 1202.5 11500KV motors I chose are perfect for this build and deliver a lot of power. With a 1S Lipo this build accelerates very quickly and reacts very well to the smallest addition of gas. I use 2 blade props to achieve a high level of efficiency. With a LiIon 21700 4200mAh it is a very heavy quad. However, I achieve a flight time of over 22 minutes but the power decreases a lot after 20 minutes.
AIO: Happymodel X12 12A VTX AIO 5in1 or BetaFPV F4 1S AIO 12A ELRS 2.4G V2.2
Motors: RcinPower 1202.5 11500KV
Props: Gemfan 3018 (Shaft 1.5mm)
Battery: Lipo 1S 850mAh, Li Ion 21700 Molicel P42a 45a 4200mAh with BT2.0 Connector (20+min slow flytime)
Camera: Caddx Ant Lite or Foxeer Pico Razor
Canopy: NewBeeDrone BeeBrain V2 or 3D printable Canopy by SeveSch FPV on Thingiverse https://www.thingiverse.com/thing:6268565
VTX: HGLRC Zeus Nano VTX or Eachine NANO V2 5.8GHz up to 400mW both with Microphone
or VTX Digital: HDZero Whoop Lite with HDZero Nano Lite Camera (fits perfect in my printable Canopy)
Video Antenna (full size): TrueRC OCP 5.8 U.FL SHORT RHCP (CABLE 3CM) or TrueRC The Smol
GPS: Flywoo GOKU GM10 Nano V3 GPS
Do not hesitate to contact me for changes and improvements or customizations according to your taste