We have partnered with Chris Rosser to provide the manufacturing and shipping of his design. This is not an Open source frame and we can not provide files or changes to this frame. With the purchase of this frame, we provide all CF and Hardware for the frame. Normal cutting time is about 3 - 5 days from the time of order but can be affected when there is a high cutting volume in the shop.
Please check out the designers website at https://www.aos-rc.com/ for more details or to contact them for additional details.
For any 3d printing needed for the frame, please check out https://www.brain3d.co/ and they will help with anything you need.
The toothpick class has always been about incredible flight performance in a tiny form factor. Relatively large props combined with an ultralight build provides enormous thrust to weight ratio and long flight times. The AOS T3 evolves this class while staying true to Bob Roogi's original toothpick formula.
A key limitation with ultralight frame designs is resonance performance. Placing the motors on the end of very long spindly arms creates a spring-mass system that is prone to resonance in a number of different modes. The AOS T3 uses finite element simulation to model these modes and topology optimization to identify the most efficient places to add material to counteract them, maximize stiffness and increase durability.
The result is a frame that weighs only 10g (13g with the provided 30mm Steel M2 stack screws) with no resonant modes below 200Hz. This allows you to run less filtering and higher D gains to unlock spectacular flight performance and unmatched propwash handling.
- Designed for 3" biblade props
- 1204 or 1303 motors with 9mm mounting
- 3S 300 - 450mAh battery
- 25.5x25.5mm and 20x20mm M2 mounting
- STLs available for 14mm Nano and 19mm Micro cameras
- Supports Caddx Vista and HDZero Whoop (TX5S.1) VTX
Note: We are not the designer and are not responsible if the frame is not as you hoped. We only cut the files provided and it's your responsibility you do your research about the frame before purchasing. Frames are all custom cut and are started once an order is placed. If you have any questions or concerns, please message us at [email protected]
, and someone will get back to yo as soon as possible. It is also suggested to check the Facebook groups or contact the designer if you have any other questions.
Files lasted updated with Cncmadness on Nov 7, 2022