This frame has been updated the the Cine25 EVO but can still be purchased fully from the replacement parts page if you would like.
Cine25 EVO: https://www.cncdrones.com/aos-cine25-evo.html
Replacement page: https://www.cncdrones.com/cine25-o3--replacement-parts.html
We have partnered with Chris Rosser to provide the manufacturing and shipping of his design. This is not an Open source frame and we can not provide files or changes to this frame. With the purchase of this frame, we provide all CF and Hardware for the frame. Normal cutting time is about 3 - 5 days from the time of order but can be affected when there is a high cutting volume in the shop.
Please check out the designers website at https://www.aos-rc.com/ for more details or to contact them for additional details.
For any 3d printing needed for the frame, please check out https://www.brain3d.co/ and they will help with anything you need.
Versatile front and rear facing Go Pro mounting.
Quickly adjust between full-ducts/half-ducts/prop guards.
Ultra low vibration for smooth footage (even without stabilization).
A state-of-the-art tool for Cinematic FPV.
? Designed for 2.5 inch props, no props in view.
? 2.5 mm Truss Arms
? Two 25.5 or 20 mm stacks
? 32x32mm M2 GoPro mounting holes in top and bottom plate with installed press-nuts
? XT30 pass through top plate
? Captive battery straps for lengthwise or toilet tank mounting
? Fits DJI FPV cameras or 19x19 mm cameras
? Recommended motor size 1404
? 9x9 motor mounting
? Standoffs, carbon and hardware included
Ducts do more than just protect the props, they also create aerodynamic drag that is vital for closely following slower moving targets e.g. Skateboarders
For faster targets e.g. BMX the drag from the ducts makes it hard to keep up!
The AOS Cine25 has 3D printable modular ducts that allow the drag to be adjusted. Full ducts are ideal for slower moving targets, half ducts for faster targets and no ducts for minimal drag for the fastest shots.
Versatile camera mounting:
A Cinewhoop must be a versatile tool for capturing a range of different aerial shots.
With a fully reversible top plate and additional mounting points underneath the AOS Cine25 makes it easy to capture both forward and rear facing shots over the widest range of different camera angles.
All while making sure the frame stays out of view.
Vibrations are often a cause of poor image quality with traditional Cinewhoops. They cause blurry footage as well as wobbles and bobbles that require additional stabilization to remove in post processing.
The structure of the AOS Cine25 minimizes frame resonances to deliver exceptionally clear and smooth footage.
Most Cinewhoops use injection molded plastic or 3D printed prop guards. These fragile materials often deform and crack over time potentially jamming up the props and needing replacement.
The AOS Cine25 uses carbon fiber prop guards to maximize stiffness and strength while reducing weight.
Note: We are not the designer and are not responsible if the frame is not as you hoped. We only cut the files provided and it's your responsibility you do your research about the frame before purchasing. Frames are all custom cut and are started once an order is placed. If you have any questions or concerns, please message us at [email protected]
, and someone will get back to yo as soon as possible. It is also suggested to check the Facebook groups or contact the designer if you have any other questions.
Files lasted updated with Cncmadness on Nov 21, 2022