This version of the frame has been updated to a new version. If you still wish to order this version, its available as a full kit on our replacement parts page.
We have partnered with Chris Rosser to provide the manufacturing and shipping of his design. This is not an Open source frame and we can not provide files or changes to this frame. With the purchase of this frame, we provide all CF and Hardware for the frame.
Please check out the designers website at https://www.aos-rc.com/ for more details or to contact them for additional details.
For any 3d printing needed for the frame, please check out https://www.brain3d.co/ and they will help with anything you need.
AOS 5.5 builds on the scientific approach used to design the AOS 5. It boasts
vibration performance just as good as its smaller sibling despite being capable
of handling larger props and motors. The frame has been designed from the
ground up to carry the heavier GoPro Hero 8 and Hero 9 cameras without
compromise. A combination of finite element simulation and real-world
flight testing gives this frame exceptional vibration and resonance
performance. This means you can run less filtering and higher PID gains
for a smoother and more responsive feel with greatly improved mid-throttle
oscillations and cool motors.
125g with all hardware
for up to 5.5 inch props
mm Top Plate, Bottom Plate and Sandwich Plates
30.5x30.5 mm or 20x20 mm stack in the center
more 20x20mm stacks front and rear
GoPro mounting holes in top plate
the DJI Air Unit or Caddx Vista perfectly
camera option for DJI Camera, 19mm option for Caddx cameras
motor size 2307, 2208
frame and motor screws included
Note: We are not the designer and are not responsible if the frame is not as you hoped. We only cut the files provided and it's your responsibility you do your research about the frame before purchasing. Frames are all custom cut and are started once an order is placed. If you have any questions or concerns, please message us at [email protected]
, and someone will get back to yo as soon as possible. It is also suggested to check the Facebook groups or contact the designer if you have any other questions.
Files lasted updated with Cncmadness on May 21, 2021